Continue to Site

Welcome to our site!

Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.

  • Welcome to our site! Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.

amp

  1. L

    Crunch 3500w going into protect mode..

    My crunch 3500w is going into protect mode when i turn up my radio. I have a 2008 impala with bose.. i installed a LOC to stock radio, connected power and ground to the stock amp. ran both speaker wires from LOC to correct sides of rear 2 speakers.. I grounded the amp by the spare tire on bare...
  2. A

    Turbosound Ip 3000 pa sound system schematic needed?

    Turbo sound Ip 3000 schematic needed? I have been trying to get Music Tribe Turbo sound IP 3000 schematic I got 1 that is not turning the power supply for the amp using ic tda8954th by 4 the mode pin has no power it had turn one a few time but when it gets hot the amp cut off I was told the 3rd...
  3. Justin Verrall

    (NEED HELP PLEASE!) 1w Amp build

    Hey I'm wanting to try my hand at building a simple portable 1w practice amp and I'm still very much a beginner at reading schematics and even worse at working from them so can someone tell me if I'm going in the right direction please? Pm me if you want. Schematics **broken link removed**...
  4. Clarkdale44

    Can a pwm solar cc generate 750w solar power with only 40A current?

    Hello I don't know much about solar stuff.. I have been researching a lot lately on the topic. I stumbled upon this solar inverter on ebay **broken link removed** **broken link removed** It has a pwm charge controller but what interests me is that with only 40A current 750W panals can be...
  5. J

    H-Bridge Amp for 8Ω Speaker (PWM)

    I am using fairly robust D882 and B772 transistors in my design, so I am wondering if I still need 4 damper diodes to protect the transistors as shown below? (Leaving them out saves a little on space and cost.)
  6. Clarkdale44

    Should i buy Watt Meter (aka killawatt) or regular Clamp on meter to determine the device wattage?

    Hello As the title says i need to know what should i buy? which one would give me the most accurate reading? I want to know how much power my appliances consumes, tv, washing machine etc.... Also i need to buy a new ups for my PC so just wants to know how much power my pc eats. I have a 500W...

New Articles From Microcontroller Tips

Back
Top