Hi everyone,
Hope you are doing well. I was wondering if this circuit is wired correctly to an Arduino Uno and if I need any resistors or capacitors or anything to make sure it will work properly and safely. I also don't know what kind of battery to use. Can I just use a multimeter to find out...
I tinker with small class d amp chips. I'm currently working on a MIX2052 chip 8 pin. Google shows only 1 schematic. Built amp. Amp clips at higher volumes. Does anyone know what filters I can try or any other way to eliminate the clipping? I am using a 4 ohm 3 watt speaker with a 2200maH 3.7...
I have to design a sinusiodal voltage amplifier with a voltage gain of 5400 and a specified bandwitdh . Wich soluttion is better :with transistors or with OA?
Hi there,
Someone has posted it online, but I need to explain it more clearly.
Take a look in the circuit,
1. First stage of the amplifier looks non inverting inputs are getting voltage drop, using divider R2 and R4, while inverting input is connected with same voltage source droping at R1...
This posts aims to get opinions about why solid-state audio amplifier circuits are almost invariably much more complex than valve/tube amplifier circuits.
One could think that, if a good tube circuit is just redone, susbtituting each tube by a transistor (common cathode by a common...
I'm making an assignment on this topic but so far I've encountered a few problems that I can't figure out.
For the OA I've used LM324 whose output voltage is Vcc-1.5V.So for my case I've made these calculations with input voltage of 10 V.
I have τ=100uS.UTHL= ±1mV UTHH=±1V
I can't reach the...