Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.
Welcome to our site! Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.
Hello,
I am currently working as a team on a project with our university, we have chosen to use a 3-6V - 400kV boost converter as part of the project. None of use have much knowledge on them and we're trying to troubleshoot why the two we have tried to use haven't worked.
Our circuit its just...
Recently got one of those, and I was wondering what the output voltage was. I know the input is 5V, but the very-much-standart Li-ion 18650 battery I use is 3.7V I'm planning to connect a Digispark ATTINY85 board to the output, which requires also 5V. Will the ATTINY85 work properly? I heard...
Hello,
New to forum, hope to get some advice. Sorry for the long introduction but want to provide as much info as possible to bring to light what I’ve considered and to help provide a solution. I have some background in electronics, but definitely a novice.
TLDR; I have a battery bank that I...
Hello Everyone,
I built the circuit below with the PAM2423 Boost converter IC.... Here is the datasheet.
I am wanting to use it to get about 3-4 Amps of current at 5V out of a 12,000mAH Li-ion Battery Pack, which will put out between 3V and 4.2V....
I built this exact circuit with only 2 small...
So far I've blown up 4(!) boost converters with a fairly simple circuit. Obviously I'm doing something wrong, please educate me...
The converters I've tried are https://www.ebay.co.uk/itm/191827311442 and **broken link removed**
My power source is a 5C lipo battery approx 19V 16Ah
My load is...
Hi everyone, recently I've been testing an one-leg DC-DC converter operating at boost mode.
A 400 ohms resistor is attached at vh side. TA-, DA+ are the working elements. The gate of TA+ is well shorted.
Here are the specs:
D =0.33
Input: 48V with a 330uF capacitor
Output: 144V with a...
I have a requirement to generate around 100V at 1.5A into a resistive load from a 14.4V LiFePO4 pack (rated at 60A continuous).
I've tried a couple of 600W and 1200W eBay off the shelf boost converters but they:
a) fall a bit short on voltage, typically 80V max.
b) have a maximum *input*...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
