I have a project with a step up dc/dc converter. It is a ltc3400 chip. At the moment it is working fine 2v to 4v but it seems to stop working down at 1.5v input.( The spec is 0.85v minimum input). I was wondering if anyone knows any problems that might occur as the input voltage is reduced.
Hello Everyone,
I built the circuit below with the PAM2423 Boost converter IC.... Here is the datasheet.
I am wanting to use it to get about 3-4 Amps of current at 5V out of a 12,000mAH Li-ion Battery Pack, which will put out between 3V and 4.2V....
I built this exact circuit with only 2 small...
To anyone who can help me, PLEASE!!!!!
I have a circuit board I am working on that is to have 3 outputs...
12V at 1-2A, 6.8V at 1-2A, and 33V at a higher amp rating, about 3-4A...
I have the designs attached below, and I have the board here. I have assembled 2 boards, and neither of them is...
I am working on an Active Clamp Forward converter. Schematic is given here:
Specs:
Output voltage-5V
Input voltage 26..42V
frequency=500KHz
Output power=10W
It is working fine in open loop, but in closed loop I am getting a ripple in output Voltage of 2.5Volts Peak to peak.
Voltage...
Hello!
I am using FCPF220N80 MOSfet for 400 Volts operation. it is rated for 800Volts. I have one doubts though, The clearance(distance) between the drain and source pins of the mosfet is only 2.5 mm. Will it be able to sustain without any damage...
Hello people!
I am trying to find a gate driver for IGBTs for a current-source full bridge topology. The main difference between current-fed and normal voltage-fed converters is that due to a boost inductance at the input, there should always be a path of current flow. So, as we give dead time...
Hello,
I have designed a half-bridge DC/DC converter, but I am not not sure if this works properly.
I asking cause the transformer is designed to give 380 V output (where the ratio is 7:14), but I only obtain around 277 V in the output of the converter.
I am trying to simulate a half-bridge DC/DC converter, and I would like to increase the output voltage to at least 320 V.
Do you have some suggestion on how to do that?
Hello everyone,
I am making a buck boost converter with TL494. Operating frequency is 250KHz. problem is that whenever I am increasing the duty more than 40% ,switch is getting burned. Note Input voltage is only 18 V and output current is 0.5A. I am using IRF540 . Inductor is 110uH. Can anyone...
Hello people,
I want to generate 350V from 40V using phase shift full bridge topology. Can anyone tell me where I am going wrong? How to choose magnetizing inductance? I have attached my model. Frequency of operation is 100KHz.Thanking in anticipation.Please Help
I think the output current I get from the DC/DC converter is way too low, it should be at least 6-8 A, not in mA that I got. I think the resistor that I have in the end of the converter is needed in order to obtain 400 V.
Do anyone have any suggestion what could be the problem?
I found a...
All,
I’m working a project in which I will need to control the output of a DC/DC converter using a microcontroller. I’m planning on using the LM27402 DC/DC Controller IC from TI. My application circuit will be very similar to the circuit taken from page 2 of the evaluation board datasheet and...