I was recently conceptualizing a project that required a touch screen display, so I purchased some different brands of LCDs and I wanted to make a touch screen display for a vending machine.
Finally, I decided to use STONE 15.1'' TFT LCD and Arduino for a simple simulation.
Does anyone have a...
Hi All
I work for a medical diagnostic company which develops drug/malaria/HIV/etc diagnostic tests. I have been tasked with the role of learning and developing a digital display to mitigate human error when reading the results.
I was guided to look at the ClearBlue pregnancy test (with LCD...
Hello
Currently the Grape-Express Mini development board is on Kickstarter. It's a microcontroller board like the Arduino Mega2560 R3, but this board includes a lot more than just Bluetooth, Wifi, and self-sufficiency. If there is interest, then look on the web page. The goal is not set high but...
I am planing to create kind of a display with LEDs. Round or square, the board's expected size could be around 30 x 30 cm. LEDs' position is not expected to change; just the programing of the driver. Number of LEDs expected to be, most probably, around 64, laid in straight lines. Accuracy of...
Hello everyone!
I've got a NHD-C160100DiZ-FSW-FBW display and a Simcom sim5360 module. The display is connected correctly - that is for sure. I tried to get connected using a datasheet example (using Lua language), but the display doesn't get ACK-bit - the SDA line is staying HIGH.
Here is a...
Hello again,
I'm working on a project to display the temperature of a thermocouple (I ordered the amplifier already) on a 3 digit 7 segment display, but I've never done it and I cant make much sense of what there is on the internet.
Ideally I would like to use an arduino mini or nano (I...
Recently I have been looking at driving cheap and simple 320 pix by 240 pix graphics displays with Arduino Meggas and Raspberry Pi Zeros and I noticed Nigel's comment:
@ https://www.electro-tech-online.com/threads/remote-green-house-monitor-pic-and-hc-12.149016/
Is it problematic: views...
Hello,
Regarding Renesas part number R5F100LEAFB#V0: I have its data lines and control lines tied to an LCD (operating at 5V). The R5F100LEAFB#V0 has EVDD at 3.3 V. Will the R5F100LEAFB#V0 be damaged due to the voltage mis-match to the LCD (3.3V vs. 5V)?
Thanks,
Calvin
Hi
I hava a HundaTech 4.3" I2C TFT Display (Link Below) and want to display value read from the analog pin of my arduino DUE. The communication config i using is I2C
Has anyone successfully managed to get the display on the lcd...