Here is my complete circuit
Circuit in LTspice -
ENABLE node voltage is green, input is blue, Q2 base-emitter voltage is red.
The overshoot when C1 starts up the circuit causes too much bas-emitter voltage and fries Q2…
I can lessen C1 to reduce overshoot, but then the circuit does not...
Hello Everyone, I have a problem here...
I am designing a board that I need a low voltage cutoff for...
I want to use the Enable pin to do this...
I have the circuit designed for a shutdown pin, but this is the opposite of the enable pin, right???
Here is my design in LTSpice...
So here are...