I'm a composer, curious about everything under the hood. In terms of math and physics - I'm newbie.
Recently, I stepped into the field of frequencies. There is a term "Mixer", that is dedicated to "mix" frequencies/audio signals together.
Following this thread I have a question:
Why do we need...
Please see the attached schematic. I am experimenting with a circuit for sampling an external frequency. The counters do not always count correctly. At first I suspected the breadboard and I replaced it with no success.
I would like to know if anybody understands what mistake I have in my...
I used sbl-1 mixer for decreasing signal frequency from 3.174 MHz to 10 kHz. The generated signal has high noise level. The butterworth and sallen-key filter was used to eliminate noise, nevertheless there is the noise. There is also the possibility of sending images of the circuit. How can i...
Hello. I designed some analog second-order all-pass filter in LTspice and provided Monte Carlo analysis as well. I want to evaluate the obtained AC results with .meas command, particularly:
1. Magnitude variation at pole frequency (.meas AC 'label' FIND mag(V(out)) AT 'freq value of interest')...
In case of a smps transformer of 1:2 primary and secondary turn ratio roughly the output voltage will be double & current will be half of input.
My questions are what effect will be on output, if
1) Frequency increase or decrease (when duty % is constant)
2) duty % increase or...
I wanted to build a circuit which would produce a set of signals of different frequencies in different channels simultaneously using a single reference source. I also want the frequencies to be changeable. I am looking to generate frequencies in kHz and MHz range. On searching on the web I came...
Do anyone know how to check the THD (fft) in a easy way in LTspice?
When I press the FFT-button, I got this window popping up. What should I select there?
Maybe an alternative is to do this instead:
I found somewhere that you need to write a SPICE directive like this:
".fourier {Freq}...
Hello,
What I understand it is possible to change the frequency externally by changing the components parameters, but I am not sure what to do to adjust the frequency. Can maybe someone show me how it will be implemented in the demo circuit?
According to the data sheet, it says that "The...
Hello Sir,
I have been posted this idea in another group,https://www.eevblog.com/forum/projects/a-hearing-aid-amplifier/ ;)
Many of them suggested many idea, but let me start it again for particular design,
It looks clear, I have been trying
1. Treble and Bass control by frequency...
Hi
I want to buy 2CL2FM .
http://www.hvgtsemi.com/upfile/pdf/2012110817253555456.pdf
Trr =100 ns
I want to find out the real switching frequency of the diode.
Can I apply it in the smps with 100 khz of switching frequency?
Regards
Hello, I'm new to this forum so I would like to say Hy to all.
I builded homemade electric generator. It's 2kw generator from Briggs&Stratton lawn mower engine (four stroke with carburator and centrifugal governor) and 1phase inductive industrial motor.
I managed to get motor to generate...
I got a high voltage regulator (Discrete using BJTs)..Attaching the circuit..would like to calculate the biasing values how its been arrived..the load at Q2A switch from 0 and 1.3A..If any one can help on theoretical calculation would be helpful
Hello,
I am creating a PWM signal by comparing a sine wave (50Hz) and a triangular wave arrier (10kHz) ,in ordem to control a full bridge inverter.
II had been try filter this pwm signal to obtain a sinusoide, with a LC filter. I use this equation to find a cut-frequency of the filter (and...