Hi, I'm pretty new to electronics and trying to get a HV low amperage DC power supply, somewhere in the range of 500-1kV.
I have a basic ZVS set up, hooked up to a transformer and a rectifier. I was hoping to get an arc through the gap to make sure it works. With a 1:100 ratio on the coil it...
Do mains adaptors with the DC ground connected to earth exist? / Where could I buy one?
I am making a device which is powered from a 12V, 1A mains adaptor. The device has a high voltage DC module in it which outputs about 20kV. The way it is used, the high voltage is discharged into the air...
Hi everyone.
I got a new cheap 9-v powered insulation meter (250-1000V), just to see how it works, and if it fits my needs. I never used one before. I did a couple of test, and I wanted to share them, and also ask if you think the results are to be expected.
The meter works fine when measuring...
Hi
I want to buy 2CL2FM .
http://www.hvgtsemi.com/upfile/pdf/2012110817253555456.pdf
Trr =100 ns
I want to find out the real switching frequency of the diode.
Can I apply it in the smps with 100 khz of switching frequency?
Regards
I'm working with a system that requires me to read 120VAC inputs on a pivot irrigation system. The wires travel 1/4 of a mile. Occasionally on the line I am reading, the voltage is 65VAC instead of 120VAC. I believe this is an induced voltage because of the length of the wires. I only want to...
I read many times, form many sources, that 60 VDC or 30 VAC are potentionally dangerous. I know that it is current what matters, but higher voltages lead to greater currents (assuming same resistance, of course).
I also know that primary and secondary windings of a transformer are dangerous.
But...
I probably need to replace a 16KV, 470pF doorknob type capacitor. They are very expensive, so I was thinking of putting 2x 10KV, 1nF ceramic disk type caps in series, which is much cheaper. Then my brain eventually ground round to the idea of hollowing out the original cap and putting the disk...
Background:
A friend is looking to do some fractal burning (google it) (edit: also called Lichtenberg figure)
and has salvaged a microwave oven transformer (MOT) for this purpose. However he likes to think big and isn't satisfied with the 2kV output so has asked me to look at increasing it.
As...
I've built my first-ever Tesla coil as a project and documented findings along the way here:
https://siliconjunction.wordpress.com/2017/02/20/my-first-tesla-coil-slayer-version/
I'd really appreciate any suggestions on how to improve the circuit or writing
Thanks a lot for your time
Matt
I hate procedures because they inevitably inhibit innovation and generally waste time with a load of meaningless waffle. But procedures are important.
One area that worries me is electrical safety.
Members, including me, often post schematics for circuits which involve dangerous voltages...
Dear All,
I would need for one of my research project a special nanosecond range pulse generator. This is very easy so far... But the output voltage for the generator must be in 20-40kV range! I have found some very unusual and expensive solution for this task, but I would need some relatively...
I have a problem finding information on some tubed I have
I have 6 big National Tubes
NL-6989-NE
The Tubes are new and because of their size I thought I could make some kind of cool display. The tube has a high voltage cap on the top and printed on the base along with the tube numbers is...
I must first apologize in the event I am breaking any forum rules with this question.
I have been working on a rotary spark gap tesla coil for a few weeks and have stumbled upon the question of: does it matter if the secondary and primary coils are wound in like or opposing directions? By that...