The high temperature of the power components is a known phenomenon in electronics. To overcome this challenge, the designers mount heatsinks on the components to dissipate the heat, however, in many commercial and home appliance devices, the embedded heatsink is not adequate and the air must be...
Hi, I'm new at this forum and to LTspice.
I need to know how to build either a new model or a sub-circuit for the LM358 device. Once I have the file LTspice manual tells me how to include it into the simulation.
Thanks in advance for any input on this question.
In this video, I explain some theories behind a low pass active filter circuit, then I built a simple active low pass filter using the LM358 opamp. I tested the filter's behavior using the Siglent SDG1025 waveform generator and the Siglent SDS2102X Plus oscilloscope.
I want to build Colpitts Oscillator Op-amp Circuit from here **broken link removed**
In the schematic it uses classic Op-amp 741 with 2 voltage sources. I have only Op-amp LM358 which using single voltage source.
What changes i need to do to schematic to make it work.
Imega from website...