Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.
Welcome to our site! Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.
Discussion why hanging large caps at input of CMOS logic not a good idea (Toshiba App Note) .
https://e2e.ti.com/support/logic-group/logic/f/logic-forum/883065/cmos-logic-input-capacitor-maximum-value
https://toshiba.semicon-storage.com/info/application_note_en_20210131_AKX00111.pdf?did=63525...
Hi.
I have the need to drive two MOSFET boards in opposition.
When signal from the signal generator (5v Arduino type signal)
I want two have two MOSFET boards operation is opposed
When signal is high MosFet 1 is on and MOSFET 2 is off
When signal is low, MOSFET 1 is off and MOSFET 2 is On...
I need to implement a circuit but Im having some trouble since Im novice on electronics.
I have 4 inputs. A being ON/OFF switch. B is an Inibitor. C is an Emergency and D is not an adequate ocasion.
In order to turn off the lamp I have to meet 2 conditions.
Condition 1: Switch is ON (A)...
Hi
Based on the logic table for AND gates, i should be able to use either as a simple digital switch. That is, say input 1 is running at 40khz, and input 2 is 1 Hz. Then, every second, our output should toggle between 0 for half a second, then 40kHz for half a second. Correct?
**broken link...
Any help on this problem would be very appreciated:
So I am supposed to solve a push button problem and draw the circuit, using any gates and multiplexers.
So the problem reads:
Design a sequential circuit which will output Z = 1 for exactly four clock cycles each time a person pushes a...
Hello everyone, I have a circuit and .jed file that requires a GAL16V8, however I don't have any of those handy, but I do have several GAL20V10's in stock. What sort of editing will I have to do to the .jed file (if any) to get this to work?
Sorry if this is a stupid question, this is my first...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
