Discussion why hanging large caps at input of CMOS logic not a good idea (Toshiba App Note) .
https://e2e.ti.com/support/logic-group/logic/f/logic-forum/883065/cmos-logic-input-capacitor-maximum-value
https://toshiba.semicon-storage.com/info/application_note_en_20210131_AKX00111.pdf?did=63525...
Hi.
I have the need to drive two MOSFET boards in opposition.
When signal from the signal generator (5v Arduino type signal)
I want two have two MOSFET boards operation is opposed
When signal is high MosFet 1 is on and MOSFET 2 is off
When signal is low, MOSFET 1 is off and MOSFET 2 is On...
I need to implement a circuit but Im having some trouble since Im novice on electronics.
I have 4 inputs. A being ON/OFF switch. B is an Inibitor. C is an Emergency and D is not an adequate ocasion.
In order to turn off the lamp I have to meet 2 conditions.
Condition 1: Switch is ON (A)...
Hi
Based on the logic table for AND gates, i should be able to use either as a simple digital switch. That is, say input 1 is running at 40khz, and input 2 is 1 Hz. Then, every second, our output should toggle between 0 for half a second, then 40kHz for half a second. Correct?
**broken link...
Any help on this problem would be very appreciated:
So I am supposed to solve a push button problem and draw the circuit, using any gates and multiplexers.
So the problem reads:
Design a sequential circuit which will output Z = 1 for exactly four clock cycles each time a person pushes a...
Hello everyone, I have a circuit and .jed file that requires a GAL16V8, however I don't have any of those handy, but I do have several GAL20V10's in stock. What sort of editing will I have to do to the .jed file (if any) to get this to work?
Sorry if this is a stupid question, this is my first...