Hi, we're installing a kitchen and while considering door handles, soft-close, push to open, etc etc I had one of those ideas that is far more sophisticated then we need and will inevitably prolong the pain of fitting a kitchen; I wondered if I could use an electromagnetic solenoid or car-door...
Greeting,
Thank you for your support guys.
I am a newbie to the Electronics, but I did read for a long time and search but this is my first circuit it may look easy for you but I need help.
Here are two schematic and I need them to be joined together with Op protection and reverse voltage...
Hi everyone,
I'm building my own stop action magnets for a pipe organ.
The actual action is effectively just a rod that will activate a reed switch when in the 'drawn' position, and deactivate in the 'pushed' position. I have that all under control.
The difficult part is that the whole array of...
Hi All,
First time post here. Hope you're all having a good weekend.
I'm doing a little project with a small clapper solenoid. It's one of the 5.5lb 12VDC, .25A 20mmDia. units sold on ebay. (ZYE1 P20/15). Though I don't have this one yet, so can give you the coil resistance, I'm working with one...
heres my project and or idea.... im trying to use a two way radio to signal another two way radio. i have 12 VDC magnetic solenoid thats hooked to a bird launcher(big sling shot used for training retrievers). when solenoid receives power it retracts in turn releasing the latch.... i have done...