I've attached the USB host cable to the USB Host pins on the Teensy 4.1, my midi controller comes on when plugged into it and I've created this simple sketch to print out the CC number of any messages received, however it's not printing anything. This code has been cobbled together from bits...
I have an ST7735 (from A-ZDelivery) and a Teensy 4.1, whatever I do I just can get the screen to even come on at all, its connected up as follows:
LED > 36
SCK > 13
SDA > 11
A0 > 33
RESET > 7
CS > 2
GROUND > GROUND
VCC > 5V
#include <Adafruit_GFX.h> // Include the Adafruit GFX Library...
Hello eveyone,
I have a wired analog Accelerometer (KS943B100) IEPE output, BNC connectors. It is actually connected to an NI cDAQ-9171 with serial connection and then to the PC with labVIEW.
My objective is to make this application wireless by connecting the sensor to an MCU, send the data...
Hello! I have a project that involves a teensy 3.2 and a BLE HM-10 module.
I actually need to wirelessly connect a myo armband to my teensy microcontroller through HM-10.
I successfully connected the said components but it is through an Arduino UNO and not teensy. However, I need to use a teensy...
Hi Everyone.
So I have a two teensy 3.2 boards and I would like to create a serial communication between the two.
I found a tutorial on Instructables.com: https://www.instructables.com/id/Com...-Arduinos-I2C/. However, the author uses two Arduino Uno.
I tried doing the same thing on my two...