Recently got one of those, and I was wondering what the output voltage was. I know the input is 5V, but the very-much-standart Li-ion 18650 battery I use is 3.7V I'm planning to connect a Digispark ATTINY85 board to the output, which requires also 5V. Will the ATTINY85 work properly? I heard...
Hello everyone. I would be very grateful if you can help me with this circuit I am working on (sch.png).
It consists of a TP4056 charger/controller (Photo 2) connected to a 3.7v/3Ah Lithium Ion battery to supply a low battery level indicator, and a load (three white leds and two fans) through a...
Hi,
I am new here and hope that you can answer a quick question about a little project of mine.
I would like to charge a 100ma/h 3,7 v Lipo with a TP4056.
The current can be adjusted by changing the resistor on the board. (datasheet says from 100mA to 130mA...I read, that you can also get...