mhtavallaie
New Member
dear colleagues
I am using a temperature controller which provides a 10 volt DC 20 ma output when the ampient temperature is less than its set point value.
the question is how can I use this 10 volt signal for switching on and control of thyristor modules which feed a 3 phase 36kw heater?
your comments is highly appreciated in advance.
rgds
hadi
I am using a temperature controller which provides a 10 volt DC 20 ma output when the ampient temperature is less than its set point value.
the question is how can I use this 10 volt signal for switching on and control of thyristor modules which feed a 3 phase 36kw heater?
your comments is highly appreciated in advance.
rgds
hadi