Hey
I am kinda new at electronics, so this might be something very simple that I am overlooking. I heard that you can use a MAX666 to convert 3vDC to 5vDC, which is what I need for a project I am working on. I have the circuit wired exactly the way that the MAX666 datasheet describes for the programmable voltage regulator settings, but no matter what I do, I can never get the output higher than ~2.6 volts.
My value for R1 is 1MΩ. R2 = 2.9MΩ
Any help would be appreciated. Or if there were an easier way to do this.
Thanks