numberonekiwi
New Member
As I understand the 4013 the output of q and q(bar) are usually opposite but I am looking at trying to use this circuit for a dual cell HHO generator so that only one cell is getting power at any one time which in theory would half the power consumption of having two in parallel with DC
So my idea was to use Q and Q(bar) to each drive a 60n06 mosfet and input a clock signal one of the inputs with a varying frequency as I am not sure on the ideal frequency yet
I however am not 100% sure on how to configure or wire this circuit do I simply connect S and D to ground and feed the CLK with pulses to get Q and Q(bar) opposite and if I do will the output frequency be the same or half ?
Also will the 4013 operate upto and beyond 50Khz in this setup?
Not sure what I am going to use as an adjustable CLK source yet maybe a 555 if the frequency goes high enough
From a newbie here
So my idea was to use Q and Q(bar) to each drive a 60n06 mosfet and input a clock signal one of the inputs with a varying frequency as I am not sure on the ideal frequency yet
I however am not 100% sure on how to configure or wire this circuit do I simply connect S and D to ground and feed the CLK with pulses to get Q and Q(bar) opposite and if I do will the output frequency be the same or half ?
Also will the 4013 operate upto and beyond 50Khz in this setup?
Not sure what I am going to use as an adjustable CLK source yet maybe a 555 if the frequency goes high enough
From a newbie here