Lads-
So, I've recently stumbled upon this 5 LED flasher kit that I think I can modify to fit my needs. What I am looking for is this:
I want to have a Y-formation of LEDs for a dashboard "Flux Capacitor" I'm working on for funsies. Each branch of the Y will have 3 LEDs, 9 total. The flash sequence (if you've seen Back to the Future) will be Outer, Middle, Inner, and repeat.
I believe, looking at this kit and its schematic, that I can modify the 5 LED flasher to 9 by wiring 3 out of the 5 into my 3-LED branches. Essentially, take 2 out of the 5, wire 3 in each of the other 3 ports, replaced the 3 Volt power source with a 9 volt, and jumper the empty spots. Make sense?
Well, that's my question. Judging by this schematic, I think...and I'm a novice...think I can do this. But, is it just as simple as: removing the 100R resistor and jumper the empty spots? What am I missing? How would you do it? Let me know. Thanks.
**broken link removed**