jazzyflymc
New Member
Hi,
I'm using an PIC16F74 for reading & transmmmiting (to a bluetooth module) 8 signals from 8 pressure sensors. Using only one of the 8 inputs would be simple, but I can't figure out how to write the assembler code for using all 8 PIC inputs (that is changing to the next input each time a A/D conversion has been made by reading 1 of the 8 inputs, and than starting all over again).
I would be gratefull if someone that has done this job before could provide me the code.
Thanks
I'm using an PIC16F74 for reading & transmmmiting (to a bluetooth module) 8 signals from 8 pressure sensors. Using only one of the 8 inputs would be simple, but I can't figure out how to write the assembler code for using all 8 PIC inputs (that is changing to the next input each time a A/D conversion has been made by reading 1 of the 8 inputs, and than starting all over again).
I would be gratefull if someone that has done this job before could provide me the code.
Thanks