Hello!
I'm building a line follower, as some of you may know and I'm having troubles with the one Cds sensor. With my multimeter, I get about ~.8 V off the line and ~2 V on the line. When I finished my program / robot building and tested it out, it doesn't work.
Now, I've gone through the code for a few days now, pretty much got rid of anything not needed and all that I can point my finger towards is the AD values.
So I was wondering, what values would the PIC see from the AD port... would they be any different than above?
Thanks!
I would like to add that I am programming in BASIC (Great Cow Basic http://gcbasic.sourceforge.net/)
I'm building a line follower, as some of you may know and I'm having troubles with the one Cds sensor. With my multimeter, I get about ~.8 V off the line and ~2 V on the line. When I finished my program / robot building and tested it out, it doesn't work.
Now, I've gone through the code for a few days now, pretty much got rid of anything not needed and all that I can point my finger towards is the AD values.
So I was wondering, what values would the PIC see from the AD port... would they be any different than above?
Thanks!
I would like to add that I am programming in BASIC (Great Cow Basic http://gcbasic.sourceforge.net/)
Last edited: