AC/DC Transformer with 240V output

ChrisP58 said:
Do you have, or are willing to create, a schematic for your actual board?
- Including all known part numbers and values, and clearly marked all input and output connections.
Click to expand...
Would love to. It looks simple enough. I mean its two sided, i can see through the PCB somewhat so re-creating the trace should be easy. Turning it into a schematic would be challenging for me anyway but I will get it.
We have an idea of what the Dimable Driver is (AL1698) but I would need help identifying the 3 pin transformer.
 
Let me know how I did. Was not sure where R1 connected as it is so close to the IC.
It is also apparent that the IC pin outs do not match with what is on the original PCB. I could use a little help trying to figure out what that IC is so I can update the schematic.
Edited for corrections

 
Last edited:
Just in case anyone is concerned about my safety I have no intention of producing this or repairing the one I have. I'm doing this for the educational value.
 
alec_t said:
Your supply + and _ seem the wrong way round in the schematic.
Click to expand...
You haven't been following the theme of this thread. Correctness doesn't matter, we are just supposed to use assumptions and common sense - ignore the errors. Read the first 10 or 20 posts.
 
I can tell now that R1 & R2 connect to pin 7 of the IC. The glue made it difficult to remove the components.

 
alec_t said:
Your supply + and _ seem the wrong way round in the schematic.
Click to expand...
It looks as if it is wrong then on the PCB. The Resistor R5 connects to D2 & D4 but the PCB has that input labeled as "L". Not sure what else to do. Anything else to add?

 
Last edited:
Without a flyback diode somewhere in this circuit , I think my 1st assumption of a constant current limiter seems more likely.

The IC in #49 is incorrectly matched to the rest of the circuit.

L1 is clearly a choke reference (aka Inductor) and the 3rd pin is mechanical.

If you want to learn how to trace details, so oblique lighting from the best angle to catch part numbers sanded off for secrecy. The top left corner is the code in 2 or 3 characters that defines a custom code by the Mfr for the public P/N. The other characters are batch date code and factory info for traceability.



FWIW
For better view of copper , a light table or underside flood light for top side transparency of the insulation.

We use the word "side" for PCB sides and your previous two side shots would be called two adjacent views of top side.
 
Like to figure out what the value of this inverter/choke is. Found a few letters and digits on the top.

 
Nigel Goodwin said:
It will be custom wound, the numbers are meaningless.
Click to expand...
That's fine. I have learned a great deal. What started out as an inquiry turned into a complete de-construction of the entire circuit. I think the only thing left is if I got the schematic correct. Post #56 is the most recent version.
 
You must log in or register to reply here.

Similar threads

C
Components for AC-DC rectifier
Replies
13
Views
993
danadak
M
  • Question
PSU "Schematic" help me understand AC/DC Bridge Rectifiers, Proper Grounding, and Series AC Connections
Replies
8
Views
2K
Tony Stewart
Test an AC Current Sensor Transformer
Replies
5
Views
3K
aliarifat794
A
D
  • Question
Combine two AC-DC adaptors to increase the amps
Replies
7
Views
3K
DerZauss
D
  • Question
Buck converter with transformer output
Replies
14
Views
3K
throbscottle
Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…