secretreeve
New Member
i everyone, firstly, thanks for taking the time to read and hopefully help me out.
im not an electrician but have some fair know how for small electrical projects, but i could use some majour help on this project i have going.
basically im looking to take 1x 12v NiMh rechargable battery and run 3 devices from it, but i would like to be able to route its power through to 3 outputs where i can manually adjust the voltage and amperage of each output.
the outputs im looking at getting are 12v, 2000Ma and 2x 5v 1amp outputs, but both factors for each output MUST be variable between 1v - 12v and 0.5A to 2.5A (or higher).
im looking at placing the circuitry onto a basic breadboard for testing initialy then over to one of those copper plated boards with the holes in, (project boards?)
so i'd really appreciate some straight forward/easy to read instructions or schematic with what components to use.
can anyone help me out with that?
thanks again for reading and hope someone can help me out.
im not an electrician but have some fair know how for small electrical projects, but i could use some majour help on this project i have going.
basically im looking to take 1x 12v NiMh rechargable battery and run 3 devices from it, but i would like to be able to route its power through to 3 outputs where i can manually adjust the voltage and amperage of each output.
the outputs im looking at getting are 12v, 2000Ma and 2x 5v 1amp outputs, but both factors for each output MUST be variable between 1v - 12v and 0.5A to 2.5A (or higher).
im looking at placing the circuitry onto a basic breadboard for testing initialy then over to one of those copper plated boards with the holes in, (project boards?)
so i'd really appreciate some straight forward/easy to read instructions or schematic with what components to use.
can anyone help me out with that?
thanks again for reading and hope someone can help me out.