linuxglobal
New Member
I have this switch that i want to use for a step motor.
I know this circuit board is used to control 2 step motors.
Anybody know what circuit i need to get this going, its hooked up to 4 pins that are currently empty. It seems to have 3 steps, low med and high. These positions need to be fixed.
Im assuming the part im missing is some sort of signal generator.
**broken link removed**
**broken link removed**
**broken link removed**
the little chip would go in the amber marked holes. I dont know if its a chip or generator. The plug pins that are used are 1,2,3,8. If that means anything LOL
Any help would be greatly appreiciated.
I know this circuit board is used to control 2 step motors.
Anybody know what circuit i need to get this going, its hooked up to 4 pins that are currently empty. It seems to have 3 steps, low med and high. These positions need to be fixed.
Im assuming the part im missing is some sort of signal generator.
**broken link removed**
**broken link removed**
**broken link removed**
the little chip would go in the amber marked holes. I dont know if its a chip or generator. The plug pins that are used are 1,2,3,8. If that means anything LOL
Any help would be greatly appreiciated.