I would like to just pop the question first, I run a fairly high performance audio system in my home and would like to switch over from passive crossovers to actives BUT I was curious if the networks could be created in a fashion that they mount in the speaker and operate at speaker level voltages rather than line level that is typically done? I realize they typically operate before the amps but I would like to avoid getting another amp just to get digital adjustment of my networks.
I also know that most people prefer nothing impeding the signal between amp and speaker so this would be a bit of a trade off. Actual power levels even at the speaker are relatively low so just thought I might ask...
I also know that most people prefer nothing impeding the signal between amp and speaker so this would be a bit of a trade off. Actual power levels even at the speaker are relatively low so just thought I might ask...