Our company has been given a job that requires reading what's inside a ATtiny13V (protection fuses not blown) – rewrite some of the code and program 2,500 new ones.
Anyone out there brave enough to take this on and give me a cost to do so? You can contact me direct at dduncan@strottman.com
Our company has been given a job that requires reading what's inside a ATtiny13V (protection fuses not blown) – rewrite some of the code and program 2,500 new ones.
Dave
Well, reading the Tiny13 is not hard. But you are saying read it, disassemble it and figure the code out (comment it), and then modify the code? And I would think that person that can/would/try to do this would not be the one to make 2500 of them. But I have kids and a programmer. .. Would you not send them out for programming at a shop that does that?
Any idea what the chip does. It might be easier to get a new program done.
Do you have the target board the chip goes in? Schematics for it? Why is there no source code?