i am able to configure bluetooth using hyperterminal and also able to communicate but how to do it using microcontroller . i have seen the commands that i am sending from the microcontroller in the hyperterminal they are as expected . i donno wat is wrong. so guys cud u plz help me
Do you have the UART setup for the correct baud rate etc ?
Four signals are provide for UART function. TXD and RXD transmit data between
AUBTM-20 and the host. NRTS and NCTS provides the RS232 hardware flow control
mechanism. All UART pins are CMOS logic with signal levels of 0V to VDD.
I bought an aubtm23 chip and I want to use it to act as a bluetooth transmitter, i.e. to receive sound from microphone port and send it via bluetooth to a bluetooth speaker or handsfree. It is act as a bluetooth handsfree by default. May you please guide me to make it?