hey everyone...
we are making a project named automatic college bell..
want to run that circuit on multisim10..
but i dont know how to run multisim..
here i am attaching the circuit..
and secondly i want to ask about its programming..
how to check whether it is correct or not?
attaching program too..
i am using AT89S8252 controller..View attachment 61420View attachment 61421
how to write on chip?
then i m going to make a project named said above.. n it is about it performs automatically..
putting a RTC and when i set a alarm time and if it matches with the RTC time.. then the alarm rings...