David_by_the_Bay
New Member
Hi -
I am new to electronics and this board. I have built a little circuit to install in a motorcycle. It provides an extra turn signal indicator. I'm wondering how much I need to filter the 12v power I feed it.
The circuit is very basic. It uses just two 555 timers plus LEDs and several passives. No microcontrollers. It all runs on 12 volts and less than 150 mA.
Can I hook it directly to the 12V supply from the bike or do I need filtering?
Thanks,
David
I am new to electronics and this board. I have built a little circuit to install in a motorcycle. It provides an extra turn signal indicator. I'm wondering how much I need to filter the 12v power I feed it.
The circuit is very basic. It uses just two 555 timers plus LEDs and several passives. No microcontrollers. It all runs on 12 volts and less than 150 mA.
Can I hook it directly to the 12V supply from the bike or do I need filtering?
Thanks,
David