2PAC Mafia
Member
Hi everybody,
in this case I have this Bose equipment where the remote command is not working. I already checked the remote and it had a coil broken inside, I repaired it and after that the equipment is still not recognizing the remote commands. I checked the remote transmitter and it works now.
I have checked the signal and I see I get the signal at CD20_3 schematic RF_Data which goes into the processor. After that I don´t know what else I can check...
I´ve been thinking about the possibility of a problem at the EEPROM where it´s stored all the matching data with the remote transmitter but at service manual is not saying anything about reconfiguring it.
What do you think?
I leave you the schematics and service manual I found in Internet.
in this case I have this Bose equipment where the remote command is not working. I already checked the remote and it had a coil broken inside, I repaired it and after that the equipment is still not recognizing the remote commands. I checked the remote transmitter and it works now.
I have checked the signal and I see I get the signal at CD20_3 schematic RF_Data which goes into the processor. After that I don´t know what else I can check...
I´ve been thinking about the possibility of a problem at the EEPROM where it´s stored all the matching data with the remote transmitter but at service manual is not saying anything about reconfiguring it.
What do you think?
I leave you the schematics and service manual I found in Internet.