Breadboard Buddy Pro

[AtomSoft]

Some Specs:

• UART is CP2104
• Regulator is SP6203 (500mA) 3.3v
• 5v from USB
• LEDs use 1k resistors so not to drain LIPO
• MicroUSB Connector

The Uses

• Program a breadboard-ed AVR/Arduino. (Arduino is basically a bootloader)
• Program a breadboard-ed PIC. (with UART bootloader)
• Program any MCU with a UART bootloader.
• Communicate with an IC or MCU with UART.
• Power your design with 2 separate rails. 3.3v and 5v
• Built in Reset Button for resetting a MCU/IC. With Optional pullup to 3.3v or 5v
• Built in Lipo Charge Circuit
• Built in TX,RX leds
• Both power rails have 1uf capacitors to help smooth them out.
• DTR, CTS also available
• Plugs right into your breadboard power rails and data rails.

Check it out: https://www.indiegogo.com/projects/breadboard-buddy-pro/x/776492