Hi all,
Can the baud rate of a pic program be changed whilst it is running, or does the pic have to be reset/restarted to effect a baud rate change ?
Any advice would be appreciated.
Regards
Ryteker
Hi OBW0549,
Thanks for your quick reply.
Having read again saections of the data sheet, it does indeed imply that it can be changed during active processing, this is indicated on a few lines on page 275 in section 6.3.
I'll have a play now that it does appear to be able to be achieved.
Thanks again.
Hi OBW0549,
Thanks for your quick reply.
Having read again saections of the data sheet, it does indeed imply that it can be changed during active processing, this is indicated on a few lines on page 275 in section 6.3.
I'll have a play now that it does appear to be able to be achieved.