I'm looking to get three PCBs made.
They are 60x15mm, single sided, no holes to drill, no silkscreen needed, no solder-resist needed. Minimum spacing/clearance is 13mil. So basically a very small, simple board.
However, I'm struggling to find somewhere that will make it cheaply. BatchPCB are the best I have found, at $10USD setup and $2.50 per square inch. However, that pays for two layers, two silkscreens, two solder-resists and unlimited plated holes.
That works out at $20 for the three boards, and I don't think that includes postage.
Futurlec do a basic service, costing $16 USD for a single sided board with no mask or silk.
Does anyone know anywhere where I can get these three boards made for any less than this? Any suggestions appriciated.
Thanks
Andrew
By the way, I'm in the UK.