Hey guys! Im new here and new to all this electronic goodness
I want to figure out LCD's. I have read a little and decided to dive in, go figure im lost. I started out pulling apart a nokia cell phone then came to conclude that everythign is too tiny to start out as a novice with. So I pulled apart my 92 BMW AM/FM Casset Stereo to snag it's LCD. I got it apart got the LCD and the connectors were great cuz it was like a plug'n'play part so I desolderd the male connector from the main board.
So here's what I got:
1x LCD.
1x Circut Board, that the LCD is solderd to w/ a LCD Driver(Sanyo LC7582, it was labled on it
) on the back.
1x
LCD Driver sheet.
The board has the connector CN-13. The male piece has 8-connectors in a straight line. The female piece is soldered to the board at 16 pins, labled;
(From Top-Bott, Top being it holding it to read properly)
- LGND *
* CDT *
* GND *
* CCK *
* +B *
* VDD2 * (Last D could be an or an "O" or 'Zero')
* LCE *
* LINH -
the * means the through pin sticks straight up after the solder and the - means that the throuh pin is folded over after the solder.
Ultimately I have point "A" the Diagram which is french to me and point "B" which is german and I can't find out what anything means online :-(
Mainly I can't find anything about the Labels on the board. The diagrams just overwhelmed me.
Can you help me figure out what is what and give me laimans terms as to how it's working?
I do learn better that way, very comparative.
Thank you guys! Hope to hear and pass knowledge.