Connecting Motor

[baberjaved]

I finally got my L297/L298 circuit up and running... the voltages on the outputs alternate between 12V (Vs) and 0V..
But when i connect the motor.. it doesn't rotate =/
I connect one winding to OUT1 and OUT2 and the other to OUT3 and OUT4.. is it correct? (its a 2-phase Bipolar Stepper)

Also What should i set the Reset on the L297 to?

Lots of Thanks in Advance for any help

Regards
Baber Javed

 

[baberjaved]

Thanks Guy... my Mistake.. its rotating but very slow! =)