Hi, I have a couple of question about connecting with a RGB TFT Screen.
The screen that I have has a paralled input (24bits for color), a clock, vsync, hsync and a few other connections. The data sheet says that I should have a max clock of 16MHz.
Now my question is can I have a slower clock that stops once in a while, ie a 1MHz clock that runs 5ms at a time then stops (sends no data) to the screen for 5 ms. I am not sure if this would cause damage to the screen (I read that it the clock and syncs were not proper that damage could occur). I am wondering this because I have a pic that has an RTOS on it, and it would devote half of its time to updating the screen and the rest to the application.
I understand how to send the data over, and when to send what clock pulsed and sync pulses, but am not too sure about stopping the clocks.
Thanks in advance for your insight!