Controlling 4-Digid 7 segment display with custom program via USB.

Status
Not open for further replies.
F

futyseq

New Member
Hello,
I have homework and I am supposed to do exactly what is in the thread name. I successfully made 1 digit display controlled with FT232 but I don't know how to do 4 digits and definitely don't know how to make the program. Can anyone help me? I want to know stuff like which IC should I use, how to wire them etc.

Thanks a bunch!

edit: Sorry, I forgot to mention that we can't use microcontrollers. Only stuff like serial converters, RAMs, counters, 7 segment display convertors etc.
 
Last edited:
Use an FT232 to feed a microcontroller, and send serial data to the microcontroller - which then feeds the displays. You could do it all easily with an Arduino, and there are plenty of examples out there.
 
Nigel Goodwin said:
Use an FT232 to feed a microcontroller, and send serial data to the microcontroller - which then feeds the displays. You could do it all easily with an Arduino, and there are plenty of examples out there.
Click to expand...
Sorry, I forgot to mention that we can't use microcontrollers. Only stuff like serial converters, RAMs, counters, 7 segment display convertors etc.
 
If you connect the FT232 to a PC, you can bit bang SPI to a 74hc595 then cascade to 4 digits... pretty easy.. You're only issue is pins available on these FT232 boards... You would need one with at least three outputs SCK data and CS .. Most have two outs and two ins... You need one with TD, RTS and DTR...

I don't know if ant RS232 -> SPI chips are available.. I used to do it through the old 9pin serial port..
 

Old parallel port probably even easier
 
FTDI make a USB to parallel converter. It is a FT245RL. I bought one several years ago but have not yet tried using it.
If you allowed to use a UART it would make your design simpler. You could then shift the parallel data into 4 or more (Depending if you sent the data in binary or ASCII encoded form.) The output of 4 stages of the shift registers could then be fed into 4 x 7 segment decoder/drivers. What you have done so far probably performs a UART function.

Les.
 
Status
Not open for further replies.

Similar threads

F
Using Lego Technic Frames to Make Custom Enclosures
Replies
2
Views
2K
For The Popcorn
F
T
  • Question
Breakout box to test custom instrumentation cables
Replies
6
Views
2K
rjenkinsgb
N
  • Question
Controlling the shutdown pin of an IR Transceiver
Replies
3
Views
844
rjenkinsgb
  • Question
Tiny display needed
2
Replies
26
Views
7K
GH Crash
N
  • Question
Controlling multiple outlets with SSR Relay module and Arduino
2
Replies
31
Views
8K
nicofiaba
N
Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…