Thanks Nigel, that should be quite useful. However (and im probably being stupid), but i cant seem to work out the actual code that is transmitted by the remote for, say volume up.
This i show i think I should send the code for volume-up on my midi-system:
firstly, send the start pulse:
set IR-LED to 1 for 2.4ms
set IR-LED to 0 for 0.6ms
Then send the command code (volume-up):
this is where im unsure... how did you work out the code?
(i think i might have found one for a sony amp, but it might not be the same)
0 (0.6ms)
pause (0.6ms)
1 (1.2ms)
pause (0.6ms)
0 (0.6ms)
pause (0.6ms)
0 (0.6ms)
pause (0.6ms)
1 (1.2ms)
pause (0.6ms)
0 (0.6ms)
pause (0.6ms)
0 (0.6ms)
Then the device ID, which for an amp, i have found is
0 (0.6ms)
pause (0.6ms)
0 (0.6ms)
pause (0.6ms)
0 (0.6ms)
pause (0.6ms)
0 (0.6ms)
pause (0.6ms)
1 (1.2ms)
. There should then be a pause of (45ms-18ms)--> 27 ms, before repeating the sequence.
I hope you understand all that, sorry if this again seems a bit garbled, but thats how my brain is finding this right now!
Does this look right to you, or am i "way off"? :|
Thanks again in advance,
Ferg