Iam doing digital display for high voltage power supply.
In this supply I want display 0-2A current & 0-1000v voltage .Iam using 0.5 ohm 2W shunt Resister, Atmega32 controller
Can any body help me how to make signal condition circuit between shunt resister & controller by using amplifiers.
There is a similar discussion in a thread called "didital ammeter"
You need to be aware that resistors also have voltage ratings as well as power ratings. I also hope you didnt chose 2W by going 2^2*.5, as although this equates to 2W - it's a dangerous practice and you should use a 5W resistor.