Design Help with Out of Spec Stepper Motor

T

tebiekoud23

New Member
Hello,

Good day.

I'm doing a custom PCB for a stepper motor and I´ll be using a drv8825. I have followed the typical application of the IC but the motor I have doesn´t match the design requirements. I´m new to electronics, and don´t understand much yet, saying this, what I´ll need to change to match the following motor?

https://www.oyostepper.it/goods-126...-42x42x38mm-Albero-con-taglio-a-D-4-fili.html

Thank you in advance for your support.

Regards,

CSC
 
Sort by date Sort by votes
The motor is fine. All you need to do is set the current limit on the DRV8825 to no more than the motor rated current; the driver IC takes care of everything else & it will be fine on 12V or 24V.

The higher the voltage, the faster the motor can run and maintain a reasonable torque level.
 
Upvote 0 Downvote
You must log in or register to reply here.

Similar threads

J
  • Question
closed loop stepper motor
Replies
3
Views
2K
Tony Stewart
L
Controlling a Stepper Motor Valve with a DAC
Replies
4
Views
4K
Lapinrose
L
D
Failure of polypropylene motor-run capacitors
Replies
6
Views
908
MaxHeadRoom78
K
  • Question
How to determine wiring of DC motor controller
Replies
13
Views
1K
Diver300
D
M
  • Question
Controlling servo motor wirelessly with a potentiometer
Replies
11
Views
1K
aliarifat794
A
Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…