Mosaic
Well-Known Member
Hi All:
I want to create a service manual for a product I am designing. It occupies three packed 3.25" x 5" double sided PCBs,mostly 0805 and some thru hole parts. A 28 pin SOIC micro some jelly bean opamps and a TL494 are the IC's.
It's complex enough to make it hard to figure out the design after putting it down for a couple of months. It's been growing in fits and starts for about 3 years now. I add a feature every so often. This session I want to get to a beta test version.
Having never done a project this complex before I usually document by adding comments placed into the schematic on the design reasoning and noting a few testpoint voltages etc.
Does anyone have a suggestion as to a good method or example for doing such documentation?
tx
Ancel
I want to create a service manual for a product I am designing. It occupies three packed 3.25" x 5" double sided PCBs,mostly 0805 and some thru hole parts. A 28 pin SOIC micro some jelly bean opamps and a TL494 are the IC's.
It's complex enough to make it hard to figure out the design after putting it down for a couple of months. It's been growing in fits and starts for about 3 years now. I add a feature every so often. This session I want to get to a beta test version.
Having never done a project this complex before I usually document by adding comments placed into the schematic on the design reasoning and noting a few testpoint voltages etc.
Does anyone have a suggestion as to a good method or example for doing such documentation?
tx
Ancel