Oznog
Active Member
I have need to cover a couple of wire ends soldered to solder pads that would be exposed on the outside of a vehicle. Don't ask me why they're out there, long story. Just accept that there is a good reason.
There are things very near it that should not be hit with overspray, I think spray products are generally "out".
Anyhow, I was at Fry's and saw they have quite a lot of brush-on products. I see acrylic, urethane, and silicone products. None of which I have any good info on that I could base a decision on.
It needs to adhere well, some degree of UV resistance, mechanically strong because it may be brushed against, and a lot of moisture resistance.
Anybody know the relative properties of these products?
There are things very near it that should not be hit with overspray, I think spray products are generally "out".
Anyhow, I was at Fry's and saw they have quite a lot of brush-on products. I see acrylic, urethane, and silicone products. None of which I have any good info on that I could base a decision on.
It needs to adhere well, some degree of UV resistance, mechanically strong because it may be brushed against, and a lot of moisture resistance.
Anybody know the relative properties of these products?