Hey all i am trying to modify a Netgear GS108 8-Port gigabit switch with POE on 4 of the ports. Problem is that when i go to test to find out what pins 4/5 and 7/8 are in order to place the positive and negative terminals too, it shows continuity on every pin of echo of the 8!
So in other words, no matter what pin i test for, it always shows continuity so i never know what pin is not being used!
Here is a picture of the board:
**broken link removed**
**broken link removed**
Any help would be greatly appreciated since i do not want to fry it )
So in other words, no matter what pin i test for, it always shows continuity so i never know what pin is not being used!
Here is a picture of the board:
**broken link removed**
**broken link removed**
Any help would be greatly appreciated since i do not want to fry it )
Last edited: