Hi,
I work as inverter and dc / dc designer, but I'm new in three-phase motors' subject.
I should make a project sketched in the figure.
![3phinv.jpg 3phinv.jpg](https://www.electro-tech-online.com/data/attachments/97/97615-9ef8a202758ed76f539e674c087215ed.jpg)
the characteristics of the motors are in the picture.
I say the pilot will be in open loop.
how are the discrete components (MOS or igbt) dimensioned in terms of current, voltage, and dissipated power ?
To supply the three-phase bridge of what DC voltage value do I need?
What amount of power Should DC / DC has to supply?
How can I simulate the motor without having the parameters described in the model provided by spice, but only those of the figure?
Thanks any advice / lesson about it is well accepted.
I work as inverter and dc / dc designer, but I'm new in three-phase motors' subject.
I should make a project sketched in the figure.
![3phinv.jpg 3phinv.jpg](https://www.electro-tech-online.com/data/attachments/97/97615-9ef8a202758ed76f539e674c087215ed.jpg)
the characteristics of the motors are in the picture.
I say the pilot will be in open loop.
how are the discrete components (MOS or igbt) dimensioned in terms of current, voltage, and dissipated power ?
To supply the three-phase bridge of what DC voltage value do I need?
What amount of power Should DC / DC has to supply?
How can I simulate the motor without having the parameters described in the model provided by spice, but only those of the figure?
Thanks any advice / lesson about it is well accepted.