justDIY
Active Member
I'm going to be sending my first pcb out for fabrication, and I'm bringing out the fine tooth comb.
After setting the DRC specs to match the requirements of the fab company, I've fixed all the complaints. The only remaining issue is a vanity issue. I have my name and date as text, in the bottom layer. Eagle flags the text and complains about "Width"
Any ideas what I do to correct this?
After setting the DRC specs to match the requirements of the fab company, I've fixed all the complaints. The only remaining issue is a vanity issue. I have my name and date as text, in the bottom layer. Eagle flags the text and complains about "Width"
Any ideas what I do to correct this?