Andy1845c
Active Member
Does anyone here have any experiance in electrical discharge machining?
If you don't know what i'm talking about, heres the wiki artical -
http://en.wikipedia.org/wiki/Electrical_discharge_machining
I have been kinda interested in trying it. Lindsy publications ( **broken link removed** )has a book on how to build a power supply and servo setup, but I was kinda hoping I could find some similar information online for free. No luck yet, but i'm not ready to give up.
Anyone have an information or knowledge of this kind of thing?
If you don't know what i'm talking about, heres the wiki artical -
http://en.wikipedia.org/wiki/Electrical_discharge_machining
I have been kinda interested in trying it. Lindsy publications ( **broken link removed** )has a book on how to build a power supply and servo setup, but I was kinda hoping I could find some similar information online for free. No luck yet, but i'm not ready to give up.
Anyone have an information or knowledge of this kind of thing?