newelectroman
New Member
Hey All
I am building a electronic trip meter using the ic mm74c925 and displaying the output on a 7 segment LED display. Im looking for a counting circuit that counts the rotating driveshaft waveform {which is sensed by a reed relay} upto a preset value on a dip switch and then resets automaticly and outputs a high signal.
Any help would be much appreciatated
cheers Newelectroman
I am building a electronic trip meter using the ic mm74c925 and displaying the output on a 7 segment LED display. Im looking for a counting circuit that counts the rotating driveshaft waveform {which is sensed by a reed relay} upto a preset value on a dip switch and then resets automaticly and outputs a high signal.
Any help would be much appreciatated
cheers Newelectroman