EQlizer circuit--need help??

attached is the beginnings of a graphic equalizer circuit I have been working on.
Have yet to figure out what Vb is and the resistor that connects to the outputs after the capacitor?
the ribbon cable connector is for connection to the 100K lin pots
Where does one obtain linear pots that are ganged?
next I need to draw out the power supply and the bar/graph readout circuits using a peak detector circuit as suggested by audio guru
any advice would be useful
the amp is going to be 2- lm3886 68W

Vb is the bias voltage for all the transistors. It is 0.7V above half of 9V which is +5.2V but +5.0V is fine.

MrDEB said:

attached is the beginnings of a graphic equalizer circuit I have been working on.
Have yet to figure out what Vb is and the resistor that connects to the outputs after the capacitor?
the ribbon cable connector is for connection to the 100K lin pots
Where does one obtain linear pots that are ganged?
next I need to draw out the power supply and the bar/graph readout circuits using a peak detector circuit as suggested by audio guru
any advice would be useful
the amp is going to be 2- lm3886 68W

Click to expand...

perhaps you have not given complete pictures. and the 9V and other voltages including Vb may be in another section of the schematic. the Vb may be a lready derived and shared by all circuits and transistos.

please try to put the complete schematic .

this is the complete scheamatic

but still need a power supply and the pts but where to buy potenmeters?
so Vb is the ias voltage so its 5v?