After successfully uploading code and removing the FTDI programmer, and applying external regulated 5V to the ESP32 CAM, when i try to connect to the given server at 192.168....., the server does not work showing problem loading page...there is nothing. how to solve?
After successfully uploading code and removing the FTDI programmer, and applying external regulated 5V to the ESP32 CAM, when i try to connect to the given server at 192.168....., the server does not work showing problem loading page...there is nothing. how to solve?
These things ESPCAM modules need a lot more power and doesn't like ripple. You need a 1Amp 3.3v power supply with at least 100uF cap. Note that most ESPCam modules are not 5v compatible.
the router DHCP list shows that the ESP32 CAM has the same valid IP address but the page is showing nothing, (problem loading page), any further advice?
These things ESPCAM modules need a lot more power and doesn't like ripple. You need a 1Amp 3.3v power supply with at least 100uF cap. Note that most ESPCam modules are not 5v compatible.