Neil Groves
New Member
What is your favorite piece of equipment to use?
in fact i have two, first off is my oscilloscope which since buying it a while back, i don't know how i ever managed without it, it's a basic CRT 2 channel 30Mhz one but i have done some small signal projects that simply could not have been done without it, tracing the signal through the circuit and locating the hotspots was fab.
My second fav has to be my little pocket sized Analogue multimeter, i loved setting it on the Ω range and watching the needle fly across the face of the meter as it showed me where i hadn't completely broke the copper track on my strip board with the twist drill, or worse still, had forgotten to make a break at all where i needed to, the digi meter just doesn't give me the same satisfaction for some reason.
My problem is that i get right near the end of construction and rush it so i can get power into the thing and see it work lol
Neil.
in fact i have two, first off is my oscilloscope which since buying it a while back, i don't know how i ever managed without it, it's a basic CRT 2 channel 30Mhz one but i have done some small signal projects that simply could not have been done without it, tracing the signal through the circuit and locating the hotspots was fab.
My second fav has to be my little pocket sized Analogue multimeter, i loved setting it on the Ω range and watching the needle fly across the face of the meter as it showed me where i hadn't completely broke the copper track on my strip board with the twist drill, or worse still, had forgotten to make a break at all where i needed to, the digi meter just doesn't give me the same satisfaction for some reason.
My problem is that i get right near the end of construction and rush it so i can get power into the thing and see it work lol
Neil.