4pyros Well-Known Member Most Helpful Member May 6, 2014 #21 Welcome to the forum, You should have started your own thread this one is over 4 years old. I dont know if you can solder flat ribbon cable without melting the plastic. It is meant to go into a compression connector.
Welcome to the forum, You should have started your own thread this one is over 4 years old. I dont know if you can solder flat ribbon cable without melting the plastic. It is meant to go into a compression connector.
atferrari Well-Known Member Most Helpful Member May 7, 2014 #22 I've seen some with wires soldered to the naked ends (which, I know, is not what the - almost - OP is looking for). Aha, acetone you say? Good.
I've seen some with wires soldered to the naked ends (which, I know, is not what the - almost - OP is looking for). Aha, acetone you say? Good.